2008 avalanche cruise control not working

No 10mm bolt. 30 seconds to get it off with only a flat screwdriver.) Used the screw driver to pry the top off of the switch and open it up. Inside is a spring-loaded plunger and a cam (be careful taking the plunger out - there's a good bit of tension on the spring).

Oct 17, 2005. Messages. 39,234. Location. Lexington KY. Nov 21, 2010. #4. The only thing I can suggest is check to make sure the brake lights are functioning, the parking brake pedal is all the way released and check the fuses. After that your going to have to get it scan.

Jun 1, 2013. Messages. 4. Dec 7, 2013. #1. I have a 2008 LS AV, My wife told me the other day that her cruise control just stopped working, well i figured she just did not do it right, so took the AV out and sure enough the light comes on to turn it on, but it would set the cruise, What is going on with it, Would somebody have a clue as to why ...

The most common reasons a 2008 Chevrolet Avalanche cruise control isn't working are failed control module, sensor or switch issues, or throttle actuation problems. 0 %. 10 % of the time it's the. Control Module. 0 %. 10 % of the time it's the. Sensor. 0 %. 80 % of the time it's the.

Both the horn switch and cruise control switch are located in the steering wheel and therefore they share common components and circuitry. Try checking under-hood fuses #7 (7.5A), #13 (20A), #15 (40A) and #20 (40A), as well as under-dash fuses #7 (7.5A) and 21 (7.5A). If all these fuses are OK, much deeper diagnosis will need to be performed.

It can also be caused by issues with the throttle control system or the ABS. In older cruise control systems, it can be caused by a broken vacuum line. Here is a more detailed list of the possible reasons your cruise control is not working: 1. Blown Fuse. All electrical systems in the vehicle are controlled by fuses.

On average, the cost for a Chevrolet Avalanche Cruise control is not working Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location. Car Service Estimate ... 2008 Chevrolet Avalanche V8-5.3L: Service type Cruise control is not working Inspection: Estimate $94.99: Shop/Dealer Price $105.01 - $112.52:

The cruise control often disengages or doesn't work when you have a faulty brake light switch. Here's how to change it out and fix a common issue with vehic...

Failing Speed Sensor: A speed sensor has many purposes including indicating the speed of the vehicle, regulating flow of fuel and ignition timing, and operating the cruise control. If the speed sensor fails the cruise control may stop working. You may also notice that the speedometer has stopped working and the engine has more difficulty when ...

Thanks for the info. I recently discovered the same problem on my 2008 Z71. The cruise control would only work intermittently if I banged on the switch or the pedal. Also the brake lights would not come on until the pedal was nearly all the way down. I replaced the brake switch with GM Part #25981009, and now the cruise and lights both work ...

In this short video I show an example of a common issue involving a fault in the cruise control system of Chevy Silverado, Chevy Tahoe, GMC Sierra, GMC Yukon...

For some reason my cruise control has stopped working, I have changed the brake switch already, all my brake lights signal lights work fine. It was turning on for like 10 seconds then turning off. ... Cruise Control Inoperative - (Oct 5, 2012) ... 2007-2013 Chevrolet Avalanche, Silverado 2007-2014 Chevrolet Suburban, Tahoe

Try replacing the brake light switch. Sign in to reply. 3cadiav on July 10, 2015. I have had this issue twice and each occurrence required the brake light switch to be replaced. Additionally, you should have noticed an anti-skid warning light illuminated. We own a 2007 avalanche LT. Retired Air Force (30 yrs)

16,098 POSTS. As far as removing the multifunction switch, there are safety issues because of the airbag. You will have to disarm the airbag and safely remove. Safety is your responsibility. You will have to remove steering wheel, usually requires a puller. Disable the sir system/airbag. Remove the steering wheel.

Nov 15, 2015. Messages. 7. Nov 16, 2015. #1. I read as many forum posts as I could find on the issue but I wanted to check again with someone about my cruise control not working. I recently bought a 2002 Avalanche 1500. When I turn on the cruise control on the blinker switch, I can hear the module that is on the firewall under the hood click.

I've got a 2008 Chevy avalanche ltz with the auto ride system. I lifted it with a body lift with the arnott suspension lift kit but the ebm that was included did not work. They aren't going to warranty the kit. I'm currently getting "service stabilitrack, service traction control, and service abs system." I can't get them off.

Step 1 - Check the fuses. Open the fuse boxes and read the cover for fuse locations associated with cruise control. Fuses break due to age, but a blown fuse may also indicate a short in the wiring. Figure 1. A good fuse (on the left) compared to blown fuses (on the right).

SM 2008. SM 2007. SM 2006. SM 2005. SM 2004. SM 2003. Full Member. Joined Jan 10, 2002 Messages 12,693 Location ... the cruise control light on the dash will flicker. My cruise control will not work at all until I turn the AV off and start it again. No one knows why this happens and I can not figure out how to make it happen n order to find a ...

Setting cannot be done (Indicator light in combination. meter comes on when the main switch is turned ON. and they remain ON while setting.) 1. Cruise control switch circuit CC-23. 2. Stop light switch circuit CC-19. 3. Park/neutral position switch circuit (DTC P0705) AX-36.

I have read some posts, but this has me stumped. I have an 03 2500, and after a recent jaunt in the snow, I went to use the cruise (about 2 weeks after the snow), and no cruise. I don't LED's, I checked the fuses, they are OK, I have rear lights, I also unhooked the battery, but that didn't work...